Finishing An Unvented Attic

Traditionally we place hvac and ductwork and often storage up there and insulate the floor of the attic.

Finishing an unvented attic.

If your home is smaller than other homes in your area or simply lacks the necessary amount of storage or living space for your family finishing your attic is a relatively inexpensive way to increase your usable space. But according to energy star the average home loses about 20 percent of the air that moves through the hvac system due to. The acceptance of unvented conditioned attics continues to grow among builders and building officials. This allows you to install your bulkheads above the ceiling plane without the need for spray foam insulation.

An attic is simply the space between a pitched roof deck and the rest of the house. The irc has permitted unvented conditioned attics since 2006 with certain requirements. The roof deck in an unvented attic must be exceptionally airtight. By moving the vapor control layer to the roof deck it prevents moisture related problems.

With unvented attics the air barrier vapor and thermal controls are installed at the roof deck. Residential unvented attics. The same conditions apply for moisture. Converting your attic into usable finished space can increase the value of your home by maximizing the available square footage.

An alternate to spray foam insulation in an unvented attic is plenum trusses which allow you create a reverse bulkhead above the ceiling plane that is insulated. A fundamental requirement of an unvented attic assembly is the use of air impermeable insulation on the underside of the unvented roof to prevent air infiltration and exclude airborne moisture from the attic. This reduces latent air conditioning loads and provides further reductions in energy consumption. The entire attic becomes conditioned space eliminating drafts and temperature fluctuations.